Show Event Source

A powerful waveform to source code cross probing feature called Show Event Source is available during the simulation. To enable it go to Design | Settings | Trace/Debug and check Enable Show Event Source option. After that, you may right click on an event on the waveform to view the HDL driver responsible for that event.

Note: If you click on a bus then Show event source is greyed out, but if you expand the bus and click on an individual bit then you will be able to use Show event source functionality.

Ask Us a Question
x

Ask Us a Question

x
Captcha ImageReload Captcha
Incorrect data entered.
Thank you! Your question has been submitted. Please allow 1-3 business days for someone to respond to your question.
Internal error occurred. Your question was not submitted. Please contact us using Feedback form.