Starting Riviera-PRO as the Default Simulator in Intel Quartus® Prime

Riviera-PRO simulator can be launched as a default simulator from the Intel Quartus® tool. This document describes the required steps to enable the interface between Quartus Prime and Riviera-PRO. This application note has been verified on Riviera-PRO 2019.04 and Quartus Prime 18.1.

Specify the location of Riviera-PRO in Quartus Prime

In Quartus Prime, open the Options window using Tools | Options. Select the General category and under the EDA Tool Options select Riviera-PRO. Set the Location of Executable column and select a path to /bin folder in Riviera-PRO installation.

Figure 1 Tools | Options menu in Quartus Prime

Specify the simulation options in Quartus Prime

Once the location of Riviera-PRO has been defined in Quartus, simulation options for Riviera-PRO can be set using Assignments | Settings menu. Under the EDA Tool Settings category, select Simulation. In the Simulation window, select Riviera-PRO in the drop-down menu of Tool name. This would also set the defaults for the EDA Netlist Writer Settings in the same window which can be changed easily using drop-down menus. Click Apply to save all settings.

Figure 2 Assignments | EDA tool settings in Quartus Prime

NativeLink Settings

NativeLink settings are located at the bottom of Simulation category on the right hand side, as shown in Figure 3. There are three NativeLink settings for selecting the test bench for the simulation.

Figure 3 EDA Tool Settings

Now select the option of your choice from NativeLink Settings. For running the Simulation, please refer to the next section.

Running simulation with Riviera-PRO

After above mentioned settings are done, Riviera-PRO can be called from the Tools | Run EDA simulation tool menu.

Figure 4 Tools | Run simulation tool menu in Quartus Prime

Figure 5 Running Simulation

Questions and support

Aldec Customer Technical Support desks are available to assist you with any questions or technical issues. Please submit your request to Support



Printed version of site: www.aldec.com/en/support/resources/documentation/articles/1180